Section V Repairing Tool for HW Series TransmissionThe maintenance tools, repairing HW series transmission made by Sinotruck,there are shape and use method as followings:1. Labor-saving Wrench (G01).Connected bolt of HW series transmission output flange nut is tightened by 1260Nm.When dismantle or t
II. Supplementary Assembly Installation of HW 19710 SeriesTransmission① Put o ring into the middle of oil inlet hole in the back shell of transmission and ringgroove of fork axle hole of range shift, and lay grease on the o ring (see Figure3-128, 3-129). ② Choose the adjustable washer in the end cov
Section II Dismantle and Assemble of HW Series TransmissionAxle Assembly.I. Dismantle of Axle Assembly (Supplementary Axle Needs notDismantle, Change the Supplementary Axle when it Repairing) Figure 3-103 Figure 3-104 ① Lift up the middle shell, and take off the main axle and fork axle. Punch the pi
Assemble of HW50 PTO⑬ Put the needle bearing into the back end hole of input shaft of PTO, align with theinner hole of spline on the right supplementary axle, and then assemble the inputshaft of PTO to the PTO hole of back shell (see Figure 3-74). Put the paper washerof end cover on output shaft of